Here is a timelapse video that had GREAT potential, but I ran out of batteries! It starts out with me taking the clamps off of the hardened sheer clamps, then sanding and routing the edges. Brendan is on the right getting the mold ready for bending on the stem. When the angel changes, you will see Drew enter the project, we lay down plastic to catch the epoxy run off, and set up the stem mold on the ground out of the way. Notice all the clamps in the lower left hand corner. At the very end, you will see us starting to roll on epoxy to both sides of everyboard....thats when my camera died. But i'll throw up a picture of the final product.