Finally, our panels are in the finishing stage. Here, meg sands with 220, stains and seals the edges before varnishing
A detail of meg finishing a small door.
Here, Meg lays down the varnish. These will get 5-6 coats.
Here is one of the larger panels with 3 coats of varnish.
Brendan lifts out one of the sole hatches that will be cut into smaller pieces.
Dave cuts, chisels, and rasps away the area where the saildrive prop will stick out of the boat at the aft end of the keelson.
The shaft end of the saildrive engine in the boat for measurements. This is not the engine but gets attached to the engine.
The Last Shot of The Week. Brendan vacuums the final sanding job on the cabin sole.
2 comments:
It is hard work, isn't it? Thankfully, your job has finished now. It has been done well.
You guys are great. You look tired but it is worth. By the way, it will be great if you also upload the picture of the ship when it is done. It will be great if you post it in this blog.
Post a Comment